Ceys Total Barrier Aguastop Waterproofing Paint Pot

Aguastop Total Barrier by Ceys is the definitive solution for waterproofing all types of roofs, as well as for stitching and repairing cracks. Due to its exclusive Polymer Total Waterproof technology, it forms a continuous elastic membrane that is highly resistant to UV radiation and inclement weather. It allows daily pedestrian traffic, resists water stagnation and can be paved both indoors and outdoors.

CHARACTERISTICS

• Passable. Resists daily pedestrian traffic
• Tilable. You can solarize it
• Resists stagnant water
• Applicable on wet supports
• Resists contact with rain within 4 hours of being applied
• Great adhesion on multiple supports and materials

APPLICATION

• Maintenance, walkable and paving covers. (No road traffic or public attendance)
• Encounters, drainages and singular points
• Anchors, drilling, steps and rust protection of metal elements
• Areas of high humidity or adverse weather
• On materials that are difficult to adhere to: asphalt fabric with embossed aluminum, PVC, vitrified, enameled, polycarbonate, Catalan tile, uralite, stoneware, ceramic, porcelain, aluminum, zinc, mortar screeds, compression plates, etc.
• Waterproofing and leak repair work in:
• Tile roofs and even in poor condition
• Non-degraded fiber cement or wood covers
• Roofs
• Terraces and walkable terraces
• Visitable terraces with or without slope
• Flat terraces at risk of stagnant water
• Gutters, downspouts and drains
• Encounters between the roof and vertical walls
• Chimneys and Skylights
• Bridging small fissures and cracks (2 mm)
• Suitable for exterior facades without back pressure
• Ponds and non-potable water tanks

MATERIALS

• Excellent adhesion on:
  • Cement
  • Concrete
  • Wood
  • Roof tile
  • Brick
  • Aluminum
  • Zinc
  • Projected PU foam
  • Ceramics
  • Stoneware
  • Catalan tile
  • Asphalt fabric (with aluminum coating)
  • Vitrified supports
  • Polycarbonate
  • PVC (carry out prior adhesion test)

HOW TO USE

SUPPORT PREPARATION

• Completely clean the support of any remains of dirt, grease, algae, dust and disintegrated materials
• Always stir the product before use, manually or with the help of a mixer at low revolutions.
• For difficult surfaces, a thin layer of pre-priming is recommended.
• Applicable with roller, brush or trowel

FISTURES, CRACKS AND MEETING AREAS

• Cover existing cracks (<2 mm) allowing the product to penetrate. Let it dry and apply a homogeneous layer 1 mm thick around the area of possible leaks.

CIRCULATABLE COVERS

• Apply the product ensuring that it is evenly distributed over the entire surface. Apply two crossed layers at a rate of 0.75 Kg/m2 each layer. Let the product dry for 7 hours between coats.

TRANSITABLE ROOFS

• Following the previous instructions, apply the product in two crossed layers at a rate of 1 Kg/m2 per layer.

REHABILITATIONS WITH SUPERIOR TILE:

• Apply two cross coats at a rate of 0.75 Kg/m2 per coat. Between coats, add a reinforcing mesh and let dry for at least 7 hours. Complete by adding silica sand while the product is still wet to ensure proper adhesion of the tiling. Once the product is dry, tile with cement glue or Ceys Total Tech (silica sand is not required).
• If the treated surface requires very high resistance to traffic, consult the product technical sheet.

HIGH PERFORMANCE WATERPROOFING!