Box of 4 pcs concrete screws UltraCut FBS II 10 x 70 15/5/- US Fischer

The fischer UltraCut FBS II is the concrete screw for the highest demands in installation. The special saw tooth geometry enables fast cutting in concrete. When installing in ceilings or floors, there is no need to clean the boreholes. Thanks to the national approval, the multiple use in temporary anchorages is regulated, e.g. in formwork. A tangential impact spanner with a suitable impact spanner nut or a special Torx Bit is recommended for mounting the wall screw. The concrete screw is ideal, for example, for fixing railings, impact protection, supports or formwork supports.

ADVANTAGES

• With up to 3 embedding depths, UltraCut FBS II US allows the same screw to be used for different component thicknesses.
• The special saw-tooth geometry enables fast cutting into the concrete.
• There is no need to clean the drill holes during vertical installation (ceiling and floor). For floor fixings, the hole must be drilled 3 times deeper.
• The anchoring without expansion (rebate) allows for reduced edge and shaft spacings.
• The ETA approval covers applications in cracked concrete and seismic strength categories C1 and C2.
• The approved setting for concrete bolts allows the bolt to be unscrewed twice to place a maximum of 10 mm of packing under the head of the base plate or to align the fastened part, and then retighten the bolt.
• The control gauge allows re-use in temporary fixings (e.g. inclined brackets) covered by national approval.

APPLICATIONS

• Protective railings
• Consoles / Base plates
• Metal profiles
• Shelf systems
• Protective barriers
• Results / Beam fixings
• Temporary anchoring, e.g. of construction equipment
• Formwork props

CONSTRUCTION MATERIALS

• Approved for:
  • C20/25 to C50/60 concrete, cracked or uncracked.
• Also suitable for:
  • C12/15 concrete
  • Solid building materials
  • High density masonry

FUNCTIONALITY

• UltraCut FBS II is recommended for push installation.
• It is not necessary to clean the drill holes during vertical installation (ceiling and floor). For floor fixings, the hole must be drilled 3 times deeper.
• We recommend using a tangential impact screwdriver with a suitable impact screwdriver sleeve or an internal torque unit.
• The screw is correctly installed when the screw head sits flush with the bracket and cannot be screwed in deeper (visual fit check).